Some cells and flow switches require a specific orientation and straight-pipe distance. Incorrect installation can create flow errors or unreliable…
Leaks at cell unions usually involve a pinched O-ring, debris, misalignment, overtightening, or a cracked fitting. Depressurizing and inspecting the…
Repeated breaker trips can signal moisture, damaged wiring, a failing power supply, or a ground fault. Resetting repeatedly is unsafe…
A dead display or inactive controller can involve a breaker, timer, automation interlock, fuse, wiring, or failed power board. Electrical…
A replacement cell must match the controller family, capacity, software, and plumbing configuration. A connector that fits does not guarantee…
Cell life depends on generation hours, water balance, cleaning habits, sizing, and climate. Age alone is less useful than diagnostics…
Cleaning strength should match the deposit and manufacturer instructions. Gentle methods preserve the catalytic coating better than routine strong-acid soaking.…
Controller salinity is a diagnostic estimate, not always a laboratory measurement. Independent testing helps separate a true chemistry issue from…
An autofill can hide a leak while steadily diluting salt and other dissolved chemicals. Tracking meter use and performing a…
Salt does not evaporate, so a falling salt level can reveal splash-out, backwashing, overflow, or a leak followed by fresh-water…